Apparently this was fixed, it does not happen in version 46, I will proceed to close it.
In GNOME custom shortcuts, when you enter and exit 1 or more shortcuts and notifications, control center freezes.
Fedora 36 Workstation GNOME 42 stable
The issue was resolved at !1883 (merged), @zalnaRs can verify this.
When the required authorization is requested, the dialog is shown empty.
Authorization dialog | QR dialog |
---|---|
Expected result:
Note:
Not if this message in the authorization dialog is provided by GNOME, the sharing dialog does not seek to modify the network, while the message says: System policy prevents modification of network settings for all users.
This may be related to #1574
This is the expected behavior mentioned in #2847
There is a mockup in which this window becomes a page: mockup.
I'm not opposed to this, it's just to keep it in mind.
I seem to have misread, I understood that you were asking me that I am using a translator with the text of the issue.
LANG=en_US.UTF-8
LC_CTYPE="en_US.UTF-8"
LC_NUMERIC="en_US.UTF-8"
LC_TIME="en_US.UTF-8"
LC_COLLATE="en_US.UTF-8"
LC_MONETARY="en_US.UTF-8"
LC_MESSAGES="en_US.UTF-8"
LC_PAPER="en_US.UTF-8"
LC_NAME="en_US.UTF-8"
LC_ADDRESS="en_US.UTF-8"
LC_TELEPHONE="en_US.UTF-8"
LC_MEASUREMENT="en_US.UTF-8"
LC_IDENTIFICATION="en_US.UTF-8"
LC_ALL=
Yes
In the Audio Properties section, specifically within the sampling frequency, numbers exceeding four digits are displayed without a thousand separators.
Desired outcome:
It is expected that figures with more than four digits display a thousand separators. For example, transitioning from, 96000 to 96,000.
Another potential solution would be to display frequencies exceeding 1,000 Hz in kHz. For instance, from 96,000 Hz to 96 kHz.
For more information regarding sampling frequency: Sampling (signal processing) - Wikipedia
Within the Cable or Ethernet Network section, it has been observed that speeds exceeding 1,000 digits lack a thousand separators.
Desired outcome:
It is expected that figures with more than 4 digits display the thousand separators. For instance, transitioning from 1000 to 1,000.
Another potential solution would be to display speeds surpassing 1,000 Mb/s in Gb/s. For example, from 1,000 Mb/s to 1 Gb/s.
For further information regarding data rate units: Data-rate units - Wikipedia.